Snow Performance Stage II Boost Cooler Forced Induction Water Injection Kit

Keep Boost Temps Down with Boost Cooler

The Snow Performance Stage 2 Boost Cooler water-methanol injection kit is available for all forced induction applications (Supercharged/Turbocharged). With a simple handheld display screen to set your injection points, this controller can be remotely mounted or placed in a convenient place to access based on your application. The VC-30 progressive controller with included digital display and boost sensor that proportionally injects more or less water/methanol according to boost pressure. Start and full points are adjustable for engagement and delivery curve to match what the engine requires. Proportionally injecting water/methanol according to boost pressure gives an accurate delivery allowing cooling and performance improvements over a wide range for improved drivability and cooling benefits. Especially helpful for direct-injected engines to remove 100% of carbon build-up on the valves. Recommended for all street/strip driven gas forced induction vehicles using a turbo or centrifugal supercharger looking for cooling over a wide range.

Premium Construction

This kit utilizes the only OEM-approved water-methanol injection pump on the market with proprietary heat flange, twin seals, and custom motor winding to run cooler and longer than the competition. The Extreme Environment 300 PSI UHO pump is designed to be in the elements with O-Ring connections that are then sealed and potted to ensure no moisture can enter the pump internals. Compare this to pumps that use a pump “sleeve”. These sleeves will keep moisture around the pump unit leading to corrosion as well as trap heat greatly decreasing pump life. The Stage 2 comes standard with 100% methanol resistant components using stainless steel, nickel plating, EPDM, and hard anodizing to ensure years of continued use. Tie that in with new Snow Performance ACU-SEAL compression fittings for guaranteed leak-free operation even when using 100% methanol. Whether running a supercharger, turbo, or high compression motor the Stage 2 Boost Cooler will make the induction charge colder, denser, and increase 91 octane fuel to 116 octane race gas levels allowing full power all the time!

Features

• U.S.A. Made
• Adjustable Progressive Water-Methanol Engagement & Monitoring
• Recommended For Street Driven Turbo and Centrifugal Supercharger Applications
• Supports 1,000+ HP
• 100% Methanol Resistant (Stainless Steel, Nickel Plating, Hard Anodizing, EPDM)
• Snow Performance Hyper-Sonic Water Methanol Nozzle
• Snow Performance ACU-SEAL Water-Methanol Compression Fittings
• Snow Performance OEM Approved Extreme Environment 300 PSI UHO Water Methanol Pump
• Snow Performance Running “S” Engraved Low Profile Nozzle Holder
• Snow Performance Running “S” Engraved Low Profile High Flow Check Valve

How to use instructions

Installation instructions

Snow Performance Warranty

For information on Snow Performance’s warranty terms and conditions, please click here.

Purchase Disclaimer: You are hereby informed and warned to check your local, state, and federal laws before buying and installing these or any aftermarket parts to be sure whether usage is in violation. All installation-risk and use-risk is borne by the end-user and installer of these parts. Bolt Motorsports does not condone the use of emission defeat devices for any vehicles used on public streets or roadways. Bolt Motorsports will not tamper, remove, disable, or bypass emissions equipment on a motor vehicle in accordance with 40 CFR Section 86.1854.12(a)(3), Clean Air Act 40 CFR 1068.101(b). This includes software, known as tunes, that reprogram a motor vehicles electronic control module to alter engine performance and enable the removal of filters, catalysts, and other critical emissions controls. In accordance with local laws and regulations, Bolt Motorsports will not ship parts to locations where usage or installation of said part would be in violation of the aforementioned acts.